LM2940 PDF

The LM/LMC positive voltage regulator features the ability to source 1A of output current with a dropout volt- age of typically V and a maximum of. The LMN/LMC positive voltage regulator. 2• Dropout Voltage Typically V @IO = 1A features the ability to source 1A of output current with. The LM/LMC positive voltage regulator features the ability to source 1A of output current with a dropout voltage of typically V and a maximum of 1V.

Author: Dougis Nekree
Country: Mauritius
Language: English (Spanish)
Genre: Travel
Published (Last): 26 February 2012
Pages: 119
PDF File Size: 2.91 Mb
ePub File Size: 9.77 Mb
ISBN: 698-5-66558-930-9
Downloads: 26042
Price: Free* [*Free Regsitration Required]
Uploader: Zologis

I’m afraid to go further in the project attaching microcontroller, etc. See the LM datasheet for details.

LM Regulator | Modern Device

The power source is a 16v solar array I have assembled. According to what I have read on these forums, a uf cap is recommended on the input side instead l,2940 the 47uf which is recommended. Whether the or Hz ESR is relevant is tbd BUT as you have a 2 x mains input ripple that the regulator is dealing with lk2940 may be the instability trigger. Russell McMahon k 9 In second case the OKI is highly suggested.

And also separately a resistor in series for belts and braces coverage: The polarization or non-polarization is not important in and of itself. If the schematics is right, your input voltage is om2940 low, the LDR needs some headroom to regulate how much depends on your actual load. As a general rule, the higher the voltage rating the larger the size so a 0.

  WELL LOGGING AND FORMATION EVALUATION TOBY DARLING PDF

Because they don’t list ESR on data sheets or at least the ones I’m looking at. Does anyone have any ideas how I might stabilize this output?

LM Voltage Regulator Question | All About Circuits

The voltage drops to I was reading it on my break and was in a hurry. Post Your Answer Discard By clicking “Post Your Answer”, you acknowledge that you have read our updated terms of serviceprivacy policy and cookie policyand that your continued use of the website is subject to these policies.

The suggested solution in that appnote, figure 7 vs. Tying down what manufacturers really mean can be a challenge. Dec 20, 10, 1, Is the scope trace shown pm2940 under load?

LM2940CT-12 = LM2940-12

Based on the schematic above, it looks like both are non polarized and the caps will be backwards from how I have it now. Voltage Regulator Question Posted by vwadad in forum: Nov 13, 3. Do you also have the input capacitor 0. Your oscillations are at 18 Mhz where the ESR is hopefully very low.

  GOLEM XIV EBOOK

Sometimes they refuse to power up too depending on the nature of your load, or have source voltage issues. I believe that I have conformed to the guidelines in the datasheet. By clicking “Post Your Answer”, you acknowledge that you have read our updated terms of serviceprivacy policy and cookie policyand that your continued use of the website is subject to these policies.

The datasheet specifies the drop-out voltage as 0. Discussion in ‘ General Electronics Chat ‘ started by mikewashere05Nov 13, For reference, this is the LM datasheet.

I have used the LM in a number of designs with no problem using tantalum input and output caps. Is this the same when using an SX28? The average voltage at the input is around 6. Once the SX28 turns on, it displays a sequence on an 7 segment display, then rotates the motor for 2 to 5 seconds.

Do you already have an account?